Hach-Lange SC 100 - Manual (Page 35)

Operation
Relay Options
31
During calibration, analog outputs can remain active, held, or transferred to a preset mA value.
4.6 Relay Options
Refer to System Setup on page 27 for more information on the relay options menu.
4.7 Data Event Logging Options
The sc100 provides three data logs (one for each sensor and one for calculated values) and three
event logs (one for each sensor and one for the controller). The data logs store the measurement
data at selected intervals. The event log stores a variety of events that occur on the devices such
as configuration changes, alarms, and warning conditions. The data logs are stored in a packed
binary format and the event logs are stored in a CSV format. The logs can be downloaded through
the digital network port or through the service port using the service cable LZX887.
4.5.3 Release Outputs
Step Select Menu Level Confirm
1
MAIN MENU —
2
TEST/MAINT
3
HOLD OUTPUTS
4
ACTIVATION
5
RELEASE
6
Main Menu or Main Measurement Screen —
4.6.1 Navigating to the Relay Options Menu
Step Select Menu Level/Instructions Confirm
1
MAIN MENU —
2
SYSTEM SETUP
3
RELAY SETUP
4
SELECT RELAY
5
Customize the options, refer to System Setup on page 27 .
6
Main Menu or Main Measurement Screen when Relay options are configured. —