Quickstart guide – Clear-Com Tempest900 User Manual
Page 3
6
7
8
●
Plug a headset into each BeltStation.
●
To set Mic Gain, Press MENU and scroll down to Set Controls.
●
Scroll to Mic Gain and Press ENTER.
●
Set the Mic Gain for the headset that you are using; speak loudly into the
microphone and adjust the setting so that the blue TALK LED starts to flash
red. Press ENTER to save.
●
Select the desired communication channel by pressing the A or B channel
selector.
●
Adjust the headset listening volume by turning the A or B rotary control.
●
Press the TALK button to talk to others on the selected channel (the blue
flashing LED will remain lit when talk is enabled on that channel)*
●
Confirm the desired talk channel and talk status by observing the BeltStation
LCD screen.
●
Select the correct intercom type on the front of the BaseStation
» Intercom type select switch A&B controls both intercom channels A and
B.
» CLEAR-COM is used for Clear-Com and Clear-Com compatible 2-Wire
systems.
» RTS is used for RTS and RTS compatible systems.
» BAL is used for Telex AudioCom & AudioCom compatible systems.
●
Connect 3-PIN XLR cables to the back of the BaseStation for the appropriate
channel.
●
Press the left SEL button to select an intercom channel (A or B); press the
right SEL button to select 2-Wire operation.
●
Use the IN and OUT rotary controls to set the IN (from 2-Wire to BaseStation
and OUT (from BaseStation to 2-Wire) levels.
●
Perform Auto Null from the BaseStation*
●
Connect RJ-45 cables to the back of the BaseStation for the appropriate
channel.
Note: The intercom type select switches do not apply to 4-Wire
operation.*
●
Press the left SEL button to select an intercom channel (A or B).
●
Press the right SEL button to select 4-Wire operation.
●
Use the IN and OUT rotary controls to set the IN (from 4-Wire to BaseStation
and OUT (from BaseStation to 4-Wire) levels.
*Refer to the Tempest Owner’s Manual for detailed system information.
Pair BeltStations to the BaseStations
Start Communicating
Connecting to External 2-wire
Intercom Systems
Connecting to External 4-wire
Intercom Systems
5
●
Confirm the BaseStation is powered ON.
●
Confirm the BeltStation is powered OFF.
●
Connect the 3.5mm data pairing cable from the BaseStation to the BeltStation.
●
Power ON the BeltStation while observing the BeltStation LCD screen; the
BeltStation will vibrate and “Pairing Complete” will appear momentarily on the LCD
screen if pairing was successfull.
●
The BeltStation will return to the operational screen and log into the BaseStation.
●
The BeltStation will appear in the first available slot on the LCD screen.
●
Repeat for each BeltStation.
Note: BeltStations are named to their default
setting name. They can be renamed.
QuickStart Guide
Useful tips
9
9
TALK buttons can be set to three different modes: Latch, Momentary,
or Disable.
9
9
Mic gain, sidetone, and volume levels can all be set based on each
user’s needs.
9
9
Set a single BaseStation to Split or Shared mode and use an
unlimited number of BeltStations that operate in a push-to-talk/listen
only mode.
9
9
When syncing multiple BaseStations it is important to power ON
one BaseStation at a time, starting with the first BaseStation in the
sequence.
9
9
For more information on these features and other advanced settings
please refer to the Tempest Reference Manual.