Clear-Com RM-702 - Manual (Page 20)

R M - 7 0 2 T W O - C H A N N E L R E M O T E S T A T I O N 2 - 8
You can change this option so that a talk signal, rather than a call sig-
nal, interrupts the program audio on channel B. You do this by re-set-
ting an internal jumper. See the next section, “Re-Setting Program
Interrupt Options,” for instructions.
The RM-702 is shipped from the factory with all DIP switches in the off
position. To enable a function, place that DIP switch in the on position.
Figure 2-7: DIP switches
RE-SETTING PROGRAM INTERRUPT
OPTIONS
When you set one of the rear-panel program interrupt DIP switches to on for
a particular channel (A or B), any call signal activated on that channel
interupts the program audio during the call signal.
You can change this option so that activating a talk signal, rather than a call
signal, interrupts the program audio for the duration of the signal. You do this
by re-setting an internal jumper on the station’s internal circuit board.
To re-set the program interrupt option:
1. Please observe anti-static procedures. Static electricity can damage a circuit
card. Please ground yourself and tools before touching the circuit card.
2. Remove the cover of the RM-702 by removing the eight Phillips screws.
3. On the main circuit board, locate one of the following:
• For channel A: The JP5 three-pin jumper, located in the center of the
circuit board.
• For channel B: The JP6 three-pin jumper, located in the center of the
circuit board.
4. A jumper plug covers two of the three pins on each jumper. To change the
program-interrupt option on your station, do one of the following:
• For channel A: Move the jumper plug so that it covers pins 1 and 2.
This causes talk signal activation to interrupt the program audio.
Momentar
y Only T
alk B
Call-on-T
alk A
Call-on-T
alk B
Interr
upt Announce
Interr
upt Exter
nal IFB
Long Line
A
Long Line B Pro
gram Interr
upt
A
Pro
gram Interr
upt B
Pro
gram Enable
A
Pro
gram Enable B
Momentar
y Only T
alk
A
Off (Default)
On