beautypg.com

Physical installation, Description of connectors, Headset connector (front panel) – Clear-Com SB-704 User Manual

Page 25: Panel mic connector (front panel), Figure 2-5: typical mixed system wiring, Or moisture

background image

S B - 7 0 4 M A I N S T A T I O N

2 - 7

Figure 2-5: Typical Mixed System Wiring

PHYSICAL INSTALLATION

You can install the SB-704 in a standard equipment rack, or you can use it as
stand-alone unit sitting on a table or desk. For installing in an equipment rack,
the unit requires 3.5 in. (8.89 cm or 2RU) of rack space. The stations are10.5
in. (26.67 cm) in depth and require at least 2.5 in. (6.35 cm) clearance in the
rear to clear connectors and cables.

DESCRIPTION OF CONNECTORS

HEADSET CONNECTOR (FRONT PANEL)

Note: The following is a description of a recommended headset.

Mic Type --- Dynamic, see technical specifications for details

Wiring:

Pin 1 --- Mic common
Pin 2 --- Mic hot
Pin 3 --- Headphone common
Pin 4 --- Headphone hot

Note: Do not tie pin #1 and pin #3 together.

PANEL MIC CONNECTOR (FRONT PANEL)

Two plug-in panel microphones are available for use on the SB-704. The
GM-9 is 9 in. (23.04 cm) long and GM-18 is 18 in. (46.08 cm) long. The
microphone is of the electret type. The microphone has a built-in 0.25-in.

AUX

On

Off

On

Off

On

Off

ELECTRIC SHOCK DO NOT

FIRE OR SHOCK HAZARD DO NOT

EXPOSE THIS EQUIPMENT TO RAIN

TO PREVENT

TO PREVENT

WARNING:

OR MOISTURE.

CAUTION:

REMOVE COVER. NO USER

SERVICEABLE PARTS INSIDE.

REFER TO QUALIFIED SERVICE

PERSONNEL.

SB-704

HOT MIC/IFB

EXTERNAL

SPEAKER

CHANNEL A

CHANNEL C

CHANNEL B

CHANNEL D

5

10

9

1

2

3

4

PROGRAM IN

ANNOUNCE OUT

RM-704

HOT MIC/IFB

CHANNEL A

CHANNEL C

CHANNEL D

CHANNEL B

PROGRAM IN

ANNOUNCE OUT

AUX

RM-704

SB-704

1-Channel Beltpacks

utput: 30V, 1.2A Continuous, 2A Pe

ss 2 Wiring