CAME BK-12P Kit - Manual (Page 10)

Allows the control assembly to check the effi ciency of the safety devices (photoelectric cells) after each opening or closing
command. A possible photoelectric cell malfunction is identifi ed with via LED indicator fl ashing on the control panel (ref. point
10, page 8), consequently cancelling any remote control or pushbutton commands.
Electrical connection for safety test activation:
- photoelectric cell transmitters and receivers must be connected in the following way (see scheme)
- turn dip-switch 9 to ON to carry out the test.
IMPORTANT:
when carrying out the safety test function, CHECK that there are NO BRIDGES between contacts N.C.: and, if not used, on the
relative dip switches (see functions selection).
6.4 Photoelectric cells performance test
43 0
&53)"),%
48 48 48 # .#
./ .#
#
10
A
ll t
h
e d
at
a a
n
d i
n
fo
rm
at
io
n c
o
n
ta
in
ed h
er
ei
n
i
s c
o
n
si
d
er
ed
s
u
b
je
ct to c
h
an
g
e a
t a
n
y t
im
e a
n
d a
t o
u
r d
is
cr
et
io
n
ENGLISH
6.5 Gearmotor end-stop connection
Gearmotor end-stop assembly already connected for
installation on the left-hand side seen from inside.
FA FC
NC NC
COM
F U W
M
V FA FC
NC NC
COM
F U W
M
V
For right-hand installation:
- reverse FA-FC of the end stops on the terminal board;
- reverse the U-V phases of the motor on the terminal board.