CAME Ver U4512-B Kit - Manual (Page 2)

2
ENGLISH
T
h
e d
at
a a
n
d i
n
fo
rm
at
io
n r
ep
o
rt
ed
i
n
t
h
is
i
n
st
al
la
ti
o
n
m
an
u
al
a
re s
u
sc
ep
ti
b
le to c
h
an
g
e a
t a
n
y t
im
e a
n
d w
it
h
o
u
t o
b
li
g
at
io
n o
n
C
AM
E c
an
ce
ll
i a
u
to
m
at
ic
i s
.p
.a
. to n
o
ti
fy
u
se
rs
.
4.1 Automazione
4 Descrizione
2.1 Intended use
1 Legend
This symbol indicates sections to be read with particular care.
This symbol indicates sections concernig safety.
This symbol indicates notes to communicate to users.
Il prodotto in oggetto è conforme alle seguenti normative: EN 12978, UNI EN 954-1, CEI EN 60335-1, UNI EN 12453.
2 Destination and limits of use
The V700 automated kit is designed to power sectional and overhead doors installed in condominiums and residential homes.
The use of this product for purposes other than as described above and installation executed in a manner other than
as instructed in this technical manual are prohibited.
3 Riferimenti normativi
“IMPORTANT SAFETY INSTRUCTIONS FOR INSTALLATION”
“CAUTION: IMPROPER INSTALLATION MAY CAUSE SERIOUS DAMAGE, FOLLOW ALL INSTALLATION INSTRUCTIONS CAREFULLY”
“THIS MANUAL IS ONLY FOR PROFESSIONAL INSTALLERS OR QUALIFIED PERSONS”
2.2 Limits to use
24V (d.c.) gearmotor with lifting force of up to 850N for:
Counterweighted overhead doors up to 2.40m in height
Spring-balanced overhead doors up to 3.25m in height
Sectional doors up to 3.20m in height
V700 was designed and manufactured by CAME CANCELLI AUTOMATICI S.p.A. and is compliant with the safety regulations in
force. Guaranteed 24 months if not tampered with.
The automation is mainly made up of an engine block, a transmission rail – with either a belt or chain transmission system – and
a transmission arm. Inside the ABS container which features a window for the courtesy light, we fi nd: the 24V gearmotor, the
control panel, the run-limiter unit and the transformer.
The gearmotor is made up of an aluminium die cast casing, which houses a worm-screw and helical-crown gear irreversible
reduction system, lubricated by permanent fl uid grease.
The transmission guide is made of cold-pressed galvanised sheeting. At the front end there is belt/chain tension device; fastened
to the other end is an ABS support to hold up the gear motor.
Inside the transmission guide runs the traction slide which includes the emergency release mechanism and the bracket for faste-
ning to the transmission arm.
The transmission arm is available in several sizes and shapes depending on the type of garage door.
4.2 Description of the parts
GEARMOTOR SECTION
1) Protective cover
2) Gearmotor
3) Transformer
4) ZL55 circuit board
5) Standard transmission arm
6) The run-limiter unit
7) Power socket
1
4
5
3
2
7 6