CAME Ver U4512-B Kit - Manual (Page 10)

10
ENGLISH
T
h
e d
at
a a
n
d i
n
fo
rm
at
io
n r
ep
o
rt
ed
i
n
t
h
is
i
n
st
al
la
ti
o
n
m
an
u
al
a
re s
u
sc
ep
ti
b
le to c
h
an
g
e a
t a
n
y t
im
e a
n
d w
it
h
o
u
t o
b
li
g
at
io
n o
n
C
AM
E c
an
ce
ll
i a
u
to
m
at
ic
i s
.p
.a
. to n
o
ti
fy
u
se
rs
.
6.1 General description
6 lectronic control panel
The control card is powered by 230V, through the power socket and has a 50/60Hz frequency.
The command devices and accessories run on 24V. Moreover, the total accessories cannot run on more than 40W.
The card controls a duty light and possibly also a courtesy lamp, which, works in synchrony with the duty lamp to illuminate
the drive way in proximity of the door; at each opening it stays on for 2 minutes and 30 seconds.
The V0670 card may be connected to operate the automation kit with emergency batteries (see the technical documentation
attached).
The card automatically controls the following functions:
1) amperometric detection of obstructions during opening, closing and during slow down phases (with adjustable sensitivity);
2) automatic closing (adjustable);
3) working cycle (80”);
4) open-stop-close-stop command, open-close or only open;
5) reopening dueing the closing phase of the photocells;
6) obstruction detection when motor is not running;
7) maintained action;
8) pre-flashing upon opening and closing.
in the closing phase: invert the direction of movement
until completely opened;
Warning! After three, consecutive inverted
cycles, the door will stay open excluding automatic
closing function: to close the door, use the remote
control or a command button.
in the opening phase: door stops, and
subsequently closes automatically.
LAMPADE
Service E17 24V 25W
Courtesy 24V 25W
FUSES
Protection Fuse type
Motor 10A
Circuit board (line) 1,6A
Accessories 3,15A
Command devices (control unit) 315mA
Detail of the amperometric detection of obstructions: