Hydrotech DLR-4M_7M Ultraviolet Water Disinfection Unit - Manual (Page 9)

O & M Manual DLR-M, 4-7
08/05 – Rev. 6 9
Installing the UV Lamp
CAUTION UV lamp is very fragile. Do not handle it with bare hands. Use clean cotton
gloves or cloth when handling lamp to keep it free of dust or fingerprints. If
dust or fingerprints get on the lamp, wipe it with a clean cloth and alcohol.
Hg
UV lamps contain mercury.
DO NOT PUT IN TRASH.
Recycle or dispose as hazardous waste.
www.lamprecycle.org 1-866-457-6697
WARNING
This product contains a chemical
known to the State of California to cause
birth defects or other reproductive harm.
Insert lamp in
chamber
Follow these steps to install the UV lamp in the disinfection chamber.
Step Action
1 Insert the lamp into the headpiece. Gently pinch the two large tabs on the
transparent lamp clip and push until the tab locks into the groove (see step 2).
2 Make sure that the transparent tab is properly snapped into the headpiece and is
not pushed down too far.
TRANSPARENT
LAMP CLIP
HEAD PIECE
DISINFECTION
CHAMBER
GROOVE
HORIZONTAL TAB
LOCATED IN GROOVE
TAB PROPERLY
TAB NOT PROPERLY
LOCATED IN GROOVE