Hydrotech DLR-4M_7M Ultraviolet Water Disinfection Unit - Manual (Page 8)

O & M Manual DLR-M, 4-7
08/05 – Rev. 6 8
Mounting Electrical Control Box
The electrical control box can be mounted on the wall (Option A) or on the
disinfection chamber (Option B), according to the following instructions.
Option A: Wall
mount
Follow these steps to mount the electrical control box on the wall.
Step Action
1 Attach the optional wall mount bracket to the wall using suitable hardware for your wall
surface.
2 Position the keyhole slots on the back of the electrical control box over the tabs on the
wall mount bracket and slide into place.
Option B:
Chamber
mount
Follow these steps to mount the electrical control box on the disinfection chamber.
Step Action Diagram
1 Feed the electrical control box straps through the
upper and lower recessed areas on the back of the
electrical control box.
2 Position the electrical control box on the UV
disinfection chamber: Wrap the electrical box straps
around the chamber, push loose end through high
side of Q-Clip, and pull through to tighten.
IMPORTANT!
If it is necessary to remove the electrical control box strap, lift the pawl to
release the Q-Clip. You may need to use a screwdriver to lift the pawl.
P A W L
Keyhole Slots