Hydrotech 2510 AIO SXT Chemical Free Iron Filter Operation Manual User Manual
Page 10
8
NOTES:
Some items may not be shown depending on timer configuration.
The timer will discard any changes and exit User Mode if any button is not pressed for sixty seconds.
User Programming Mode Steps
1. Press the Up and Down buttons for five seconds while in
service, and the time of day is NOT set to 12:01 PM.
2. Use this display to adjust the Day Override. This option
setting is identified by “DO” in the upper left hand corner
of the screen.
THIS IS AN OPTION ONLY. PLEASE DO NOT ADjUST
BEFORE CONSULTING AN AUTHORIzED DEALER.
User Programming Mode Options
Abbreviation
Parameter
Description
DO
Day Override
The timer’s day override setting
THIS IS AN OPTION ONLY. PLEASE DO NOT ADjUST
BEFORE CONSULTING AN AUTHORIzED DEALER.
RT
Regeneration Time
The time of day that the system will regenerate (meter delayed,
timeclock, and day-of-week systems)
H
Feed Water Iron Content
The iron content in ppm of the inlet water - used to calculate
system capacity for metered systems
RC
Reserve Capacity
The fixed reserve capacity
CD
Current Day
The current day of week
Set Time of Day
1. Press and hold either the Up or Down buttons until the programming icon replaces the service icon and the
parameter display reads TD.
2. Adjust the displayed time with the Up and Down buttons.
3. When the desired time is set, press the Extra Cycle button to resume normal operation. The unit will also return to
normal operation after 5 seconds if no buttons are pressed.
Queueing a Regeneration
1. Press the Extra Cycle button. The service icon will flash to indicate that a regeneration is queued.
2. To cancel a queued regeneration, press the Extra Cycle button.
Regenerating Immediately
Press and hold the Extra Cycle button for five seconds.
Installation Tip: The 2510AIO SXT Filter should not be allowed to regenerate at the same time as any other water
treatment units. If adjustment is required, consult programming chart to adjust default regeneration time. Default setting
is 11:00 pm.)