HOMA A Series Voltage Change User Manual
A series voltage change
Publication
88FN2040A
Please Contact Technical Support At 203-736-8890 With Any Additional Questions
Please Be Prepared To Provide Pump Serial Number During Call
Page
1 of 4
A Series Voltage Change
This procedure will provide you with step by step instructions to convert the operating voltage of dual
voltage 3 phase.
Tools Needed:
5 mm Allen Wrench
Wire Cutters
Wire Strippers
Terminal Crimp Tool
Qty 3–Crimpable Wire Nuts 14 to 16 Gage
1. Remove pump from service. Disconnect
power supply. Clean and decontaminate
pump prior to working on it. See the pump
Installation, Operation, and Maintenance
Manual for detailed instructions.
2. With pump in stable, upright position,
remove the eight 5mm capscrews as
indicated.
3. With the capscrews removed, lift the
motor cap off of the pump.