HOMA Conversion Kit For Installation Of HOMA Pumps On Myers Rail Systems - Manual

Publication
88PN3025A
Please Contact Technical Support At 203-736-8890 With Any Additional Questions
Please Be Prepared To Provide Pump Serial Number During Call
Page
1 of 1
Conversion Kit For Installation Of
HOMA Pumps On Myers Rail Systems
Use existing Myers pipe nipples and union to connect the discharge of the new
HOMA pump. Once the discharge is connected continue as follows:
• Thread locking cap onto the threads of the support column. Thread on loosely as the
cap will be used for adjustment.
• Slide the support column down through the upper bracket of the Myers rail system so
that the notch is over the handle of the HOMA pump.
• Insert the clevis pin through the hole in the support column and under the handle.
• Secure the clevis pin with the cotter pin. Do not forget to bend over the ends of
the cotter pin to keep it from falling out.
• Tighten the locking cap with a wrench taking up any slack.
• Tighten the two existing locking screws in the Myers upper bracket against the
support column. This will insure proper support of the pump.