HOMA Collet Impeller Disassembly and Installation - Manual (Page 2)

Publication
88FN2010
Please Contact Technical Support At 203-736-8890 With Any Additional Questions
Please Be Prepared To Provide Pump Serial Number During Call
Page
2 of 3
D
E
F
Assembly
• Place o-ring around outside diameter and
inside diameter of distance ring, lubricate with
liquid soap, and place in impeller.(D).DO NOT
USE GREASE TO LUBRICATE.
• Lightly tap ring in with a plastic hammer.
• Loosen all screws in impeller locking
mechanism, and pull the opposite sides to
extend the mechanism. (E)
• Degrease inside and outside surface of locking
mechanism, shaft, and impeller borehole. Any
residual on these surfaces may cause collet to
slip.
• Place locking mechanism into impeller
borehole. (F)
• Lubricate inner o-ring in distance ring with
liquid soap.
• Slide impeller onto shaft until locking
mechanism reaches shoulder of the shaft.
• Be certain that the locking mechanism stays in
the proper position while installing on shaft.