ADC High Density Position Panel LSX 288 - Manual (Page 3)

8/08
•
106370AE
High
Density
LSX
288
–
Position
Panel
3 w w w . a d c . c o m • + 1 - 9 5 2 - 9 3 8 - 8 0 8 0 • 1 - 8 0 0 - 3 6 6 - 3 8 9 1
High Density LSX 288-Position Panel
Termination/Splice Panel
ADC’s 288-positon LSX panel is also available in a termination and splice configuration. While ADC
recommends off-frame splicing in high-density applications, often floor-space is limited and on-frame
splicing is required in a high density environment. In a 18-inch deep frame*, this panel solution saves
the valuable rack space often required for a dedicated splice panel. Panels can be ordered with 12-fiber
ribbon or 12-fiber stranded pigtails. Splice trays and cable clamps are included within the panel.
LSX 288-Termination and Splice Panel—Splicing in the rear eliminates rack space for a
dedicated splice point. Panel is shown here from front vantage (left) and back vantage (right)
O r d e r i n g I n f o r m a t i o n
Connector style Pigtail Type Splice Type Catalog Number
SC/APC Ribbon-Indoor Mass Fusion LSX-LL5243-A-SPL
SC/UPC Ribbon-Indoor Mass Fusion LSX-L75243-A-SPL
LC/APC Ribbon-Indoor Mass Fusion LSX-LM5243-A-SPL
LC/UPC Ribbon-Indoor Mass Fusion LSX-LK5243-A-SPL
SC/APC Stranded-Indoor Heatshrink Fusion LSX-LL1242-A-SPL
SC/UPC Stranded-Indoor Heatshrink Fusion LSX-L71242-A-SPL
LC/APC Stranded-Indoor Heatshrink Fusion LSX-LM1242-A-SPL
LC/UPC Stranded-Indoor Heatshrink Fusion LSX-LK1242-A-SPL
Termination/Splice Panels
Other configurations are available upon request. Please contact ADC Technical Assistance Center.
*See page 5 for additional accessories that accommodate the deeper panel.