Gardner Bender 1105A Operating Valve and Hose Assembly - Manual (Page 2)

6101 N. Baker Road, Milwaukee, WI 53209
Phone: (414) 352-4160
FAX (414) 352-2377
WARRANTY: GARDNER BENDER warrants its
products against defects in workmanship and
materials for 1 year from date of delivery to user.
Chain is not warranted. Warranty does not cover
ordinary wear and tear, abuse, misuse, overloading,
altered products or use of improper fluid. WARRANTY RETURN PROCEDURE: When
question of warranty claim arises, send the unit to the
nearest GB Authorized Service Center for inspection,
transportation prepaid. Furnish evidence of purchase
date. If the claim comes under the terms of our
warranty the Authorized Service Center will REPAIR
OR REPLACE PARTS AFFECTED and return the unit
prepaid. PARTS AND SERVICE: For quality workmanship and
genuine GARDNER BENDER parts, select an
Authorized GB Service Center for your repair needs.
Only repairs performed by an Authorized Service
Center displaying the official GB Authorized sign are
backed with full factory warranty. Contact GARDNER
BENDER (414) 352-4160 for the name of the nearest
GB Authorized Service Center.
REPAIR AND SERVICE INSTRUCTIONS: For repair service and parts contact your nearest GARDNER BENDER
Service Center. The Service Center will provide complete and prompt service on all GARDNER BENDER products.
RPS-0093 0110
OPERATION
The 1105A operating valve and hose assembly
controls the flow of gas from the CO
2
tank. Gas
will remain under pressure in the 1105A hose
assembly.
The 1105A operating valve accepts seal-off
assemblies from 1/2 to 6 inch capacity. See
Figure 3.
To prevent injury, always keep a firm grip on
seal-offs and operating valves. An unrestrained
hose will be uncontrollable when the operating
valve is opened to release CO
2
.
1 1.. Connect the seal-off assembly to the
operating valve.(Refer to Figure 3).
2 2.. Turn the ball lock coupling sleeve to align the
sleeve notch with the ball embedded in the
ball lock coupling.
3 3.. Pull the sleeve toward the valve and hold it
while inserting the fitting from the seal-off.
4 4.. Release the sleeve, turn the notch away from
the embedded ball to prevent releasing the
seal-off.
5 5.. Check the coupling connection by pulling the
seal-off to be certain it is seated in the valve
ball lock coupling.
Figure 3
Operating Valve and Seal-Off Coupling
6 6.. To release CO
2
gas into the hose and 1105A
operating valve, open the tank rotary valve.
7 7.. To release CO
2
depress the operating handle
on the 1105A hose assembly.
8 8.. When not using the seal-off, disconnect it
from the 1105A operating valve. Turn off the
rotary valve on the CO
2
tank and squeeze
the valve handle to release any remaining
CO
2
in the hose assembly.
STORING THE 1105A VALVE AND HOSE
ASSEMBLY
1 1.. Loosen the hose coupling nut and remove the
hose assembly.
2 2.. Place the valve and hose assembly in the
tank cart storage box.
3 3.. Install the CO
2
tank protective cap by placing
it over the rotary valve and threading it onto
the tank.