CITIZEN iDP-3410 - Manual (Page 30)

iDP-3410 User’s Manual
2) DIP Switch 2
No. Function ON OFF Factory Setting
DS2-1 Bit length 8 bits 7 bits ON
DS2-2 Parity No Yes ON
DS2-3 Odd/Even Odd Even ON
DS2-4 Communication mode DTR/DSR XON/XOFF ON
DS2-5 Baud rate ON
DS2-6
″
ON
DS2-7
″
See the table below
OFF
DS2-8 Unused
− −
OFF
Baud rate
Baud rate(bps) DS2-5 DS2-6 DS2-7
150 OFF OFF OFF
300 OFF OFF ON
600 OFF ON OFF
1200 OFF ON ON
2400 ON OFF OFF
4800 ON OFF ON
9600 ON ON OFF
19200 ON ON ON
hThe DIP switch 2 is used only for the serial interface.
(Note) Setting of the paper used simply changes the drive pulse width to the printing head; it does not
mean that 2 ply paper is not available for the 1 ply setting. The same applies to when 1 ply paper
is used for the 2 ply setting.