Burkert Type 8112 - Manual (Page 8)

5 Setup
5.1 Setup
When replacing the oscillator, make sure that all adjustment
elements are set to the settings of the old oscillator. Hence the
sensor is immediately ready for operation.
In general, all oscillators of series SW60 can be interchanged.
If you want to use an oscillator with a completely different
signal output, you have to carry out the complete setup.
The necessary, suitable operating instructions manual can be
downloaded from our homepage under Downloads.
The adjustment should be carried out acc. to the description in
the operating instructions manual.
Setup
8 Electronics module - LEVEL SWITCH 8111, 8112
Setup
32056
-EN
-060704