Burkert Type 8070 - Manual (Page 5)

16
→
Wire the device following the possibilities described
below.
7.2.1 connection of the flow transmitter
4 - 20 mA
When operating as a flow transmitter, the NPN
and PNP outputs have no function.
8022
12 - 30 V DC
GND
12 - 30 V DC
Fig. 4: Connection of the flow transmitter
English 17
7.2.2 connection of the pulse divider
Connection
of the PNP
output
12 - 30 V DC
PNP
GND
8022 e.g. PLC
GND
IN
12 - 30 V DC
NPN
GND
Connection
of the NPN
output
8022 e.g. PLC
GND
IN
V+
V+
Fig. 5: Connection of the pulse divider
English
18
8 commissioninG
note!
• Only power on the device when the cover is closed.
• Switch off the device before removing the operating
unit.
9 seTTinG anD funcTions
→
Parameterize the device depending whether it is used
as a flow transmitter or a pulse divider. Refer to the
instruction manual on the delivered CD.
10 mainTenance
The flow transmitter / pulse divider Type 8022 is maintenance-
free when operated according to these operating instructions.
English 19
11 packaGinG, TransporT,
sToraGe, Disposal
note!
Transport damage!
Inadequately protected equipment may be damaged
during transport.
• During transportation protect the device against
moisture and dirt in shock-resistant packaging.
• Do not allow the temperature to exceed or drop below
the permitted storage temperature.
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature. -20 … 65 °C
Damage to the environment.
• Dispose of the device and packaging in an environmen-
tally friendly manner.
• Observe applicable regulations on disposal and the
environment.
English