Burkert Type 8650 User Manual

Page 10

Conversion, expansion and assembly of an
existing system with individual slices

19 Inclined tie rod

Illustration:
Swing in the slice

Conversion and expansion

First loosen the clamping bolts (11) on the right-hand
supply slice.

After loosening the two inclined tie rods (19), push the
supply slice to the right.

You can move the other slices in the same way until you
reach the point at which the system is to be modiﬁ ed.

If a slice is to be added, ﬁ rst hook it into the upper edge
of the proﬁ le rail. Swing in the slice and push it to the left
up to the existing part-system.

Assembly

Reassemble the system in the reverse order.

→

Removal of individual slices

Supply slice

Release the desired module by
actuating the locking element
and swing out the module.

Note in the case of the pressure
gauge module that the hose has
to be disconnected from the
pneumatic module (see illus-
tration Hose connection of the
pressure gauge module).

→

Illustration:
Supply slice

Valve slice

Remove the valves (either
pressure-free or all locations
equipped with P shut-off) and
remove any caps from the plug
contacts.

Release the electronics mo-
dule by actuating the locking
element in the direction of
the arrow and swing out the
module.

→

Illustration:
Valve slice

Installation of individual slices

Illustration:
Hose connection of the
pressure gauge module

Supply slice

Hook the module in question into the terminal module and
swing it down until it engages.

Note with the pressure gauge module that the hose must
ﬁ rst be connected to the pressure pneumatic module
(see illustration: Hose connection of the pressure gauge
module).

Valve slice

Hook the electronic module into the terminal module.

Actuate the locking element in the direction of the arrow
and swing it in the module completely.

Screw on the valves (either pressure-free or all positions
equipped with P shut-off).

→

Removal / installation of the cover flaps

Installation

For installation, position the
cover flap in the half-open
position and then push it into
the hinge contour.

→

Illustration:
Fitting the cover ﬂ ap

Disassembly

For disassembly, swing open
the cover ﬂ ap and lift the hinge
tab carefully over the hinge
contour (e. g. with a small plain
screwdriver).

→

Illustration:
Engaging the cover ﬂ ap