EXP Computer CD Station - Manual (Page 24)

- 25 -
Linux (Red hat distribution)
The parallel port CD-ROM IDE modules consist of three parts:
4. There is a base paride module required to access the parallel ports.
(Support EPP and Bi-Direct, NOT ECP mode)
5. The second module (to load) is the manufacturer specific protocol
driver. EXP using the following drivers.
fit2 Fidelity Intl.
fit3 Fidelity Intl. TD-3000
6. The third module is a CD-ROM driver
pcd for ATAPI CD-ROM
7. Use modprobe -l to locate the three modules. On the RedHat 5.2:
paride.o /lib/modules/preferred/block
fit2.o, fit3.o /lib/modules/preferred/misc
pcd.o at /lib/modules/preferred/misc
8. Use insmod to load these drivers in the following order:
paride.o, fit2.o, fit3.o and pcd.o
Note: one may use just the fit3.o only.
9. To access the CD-ROM, make sure there is a CD disk inside the CD-
ROM drive.
10. User need to mount the CD-ROM the command is
mount /dev/pcd0 /mnt/cdrom iso9660
or if X windows is running: Go to Disk Management then mount CD.
11. Go to the /mnt/cdrom to access the CD-ROM