EXP Computer CD-420_CD-421_CD-621_CD-821 - Manual (Page 20)

- - 15
SOFTWARE INSTALLATION FOR OS/2 WARP
Before installing CD-421 device driver for OS/2 WARP, make sure your
computer is PCMCIA supported. If you are not sure about this, please
refer to the last part of this section for “Adding PCMCIA Support”.
AUTOMATIC INSTALLATION
To perform the automatic installation of CD-421 for OS/2 WARP, follow
the below steps,
1. Insert the device driver disk into a floppy disk drive on your
computer.
2. Open OS/2 System.
3. Open Drives.
4. Select Drive A or B depending on which floppy drive is containing
the device driver diskette.
5. Open “OS/2 WARP” folder.
6. Double-click on “INSTALL2.EXE” file.
7. A dialog box will be displayed for you to specify the OS/2 directory,
the I/O address for the CD-421 and the IRQ number. After
specifying the OS/2 directory, press TAB to set the I/O port and then
the IRQ. The default setting of the I/O ports are (170-177, 376-377),
and the default IRQ is 15. After completing the selection, click on
Install button to continue.
Figure 11