Emtek EMTouch Classic Style Electronic Keypad Deadbolt Locksets - Manual (Page 11)

11
IN8-EMTOUCHDB 06/24/2013
U.S. patent: 8,141,400
International patents pending.
Restoring the Lock to Factory Default Setting
• Press and hold EMTEK button for 3 seconds.
• Enter
“ 000000 ”
• After 2 beeps and 2 Green LED Flash, remove power (disconnect 9V battery)
from Lock.
• After 5 seconds, restore power (reconnect 9V battery)
• Confirm by 2 beeps and 2 Green LED Flash.
This procedure clears the lock of all users and restores the Programming Code and
2 User Codes shipped with the lock.
Function Indicators
Valid Code • 1 short beep, EMTEK button flashes
Green.
Invalid Code/Access Denied* • 1 Red LED flash
• 2 short beeps
Lock-Out Mode Error • 2 short beeps
• 1 short beep per second for duration
Access Accepted • 1 short beep
• 1 Green LED flash
Low Battery • 4 Red LED flashes
• 4 short beeps
Blackout Battery
** • 1 long Red LED flash
• 4 long beeps
Button Press Accepted • 1 Yellow LED flash
• 1 Short Beep
Outside Thumb Turn Enabled • 2 Green LED flashes
* If 3 consecutive incorrect codes are entered, the lock emits 4 short beeps and a flashing Red EMTEK
button. The lock will not accept additional input for 20 seconds (20 beeps). When the next valid code is
entered the lock will beep quickly 5 times to alert of the incorrect codes.
** Battery voltage has dropped too low; keypad will be disabled but metal key override will still work.
Keypad Operation - Beeper & LED Indicators
Place Sticker Here