Technical data, Installation, Replacing the lamp – AEG SCN71800S0 User Manual
Page 18: Closing the door
Replacing the lamp
CAUTION!
Disconnect the plug from the mains socket.
1.
Press on the rear hook and at the same
time slide the cover in the direction of
the arrow.
2.
Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the light bulb cov-
er).
3.
Fix the lamp cover into its original po-
sition.
4.
Connect the plug to the mains socket.
5.
Open the door. Make sure that the
light comes on.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer to "Installation".
3.
If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Height
1780 mm
Width
560 mm
Depth
560 mm
Rising Time
25 h
Voltage
230-240 V
Frequency
50 Hz
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
18
Technical data