eLine Technology SIP-MVD-R - Manual (Page 34)

57 58
to
7. RESETTING TO FACTORY DEFAULTS
Follow the steps below to revert all settings to factory defaults. The camera
must be connected to power to perform a factory reset.
1. Remove the camera cover
screws (2x) and remove the 1
camera cover.
2. Press and hold the white
reset button for 5 seconds
2
then release the button to
reset the camera to factory
defaults.
3. Re-attach the camera cover
and replace the camera
cover screws (2x).
NOTE: Make sure rubber seal is
firmly in place when replacing
the camera cover.
Press and hold for 5 seconds to
reset to factory defaults
Configuration
6.17.10 Mirror
Enable/disable image mirroring.
• Mirror: Select Horizontal to mirror the image horizontally, Vertical to
mirror vertically, or PictureFlipto mirror bothhorizontally and vertically.
Select Close to disable image mirroring.
6.17.11 Noise Filter (solution may not feature this setting)
Configure noise filter settings.
• Noise Filter: Select Auto for automatic noise filtering or Manual.
• Max Level: Select the maximum level for automatic noise filtering.
• Level: Select the level for manual noise filtering.
eLineTechnology.com