eLine Technology DFB Quick Start - Manual (Page 13)

8
Figure 2-2
2.1.3 Remove Lens
Please follow the steps listed below to remove lens. The interface is shown as in Figure 2-3.
z Turn the lens counter clockwise and then remove it from the camera.
z Unplug the auto lens cable socket from the auto lens connector. If you are using the manual
aperture lens, please skip to the following step.
z If there is no lens, please put the CCD protection cap back to protect the CCD.
Figure 2-3
2.2 SD Card
2.2.1 Installation
Please follow the steps listed below to install SD card. The interface is shown as in Figure 2-4
and Figure 2-5.
z Use the screwdriver to loosen the SD card protection screw in the rear panel, and then
remove the SD card protection cap from the camera.
z Install the SD card to the camera according to the proper installation position.
z Put the SD card protection cap back.
z Use the screwdriver to fix the SD card protection cap screw firmly to secure the SD card
protection cap in the camera.
eLineTechnology.com