Hardware setup – Asus P4T-F User Manual

Page 21

Text mode
Original mode

3. HARDWARE SETUP

ASUS P4T-F User’s Manual

Motherboard Settings

3. H/W SETUP

P4T-F

P4T-F USB Device Wake Up

USBPWR

+5V

+5VSB

4) USB Device Wake-up (USBPWR)

Set these jumpers to +5V to allow wake up from the S1 sleep state (CPU stopped;
RAM refreshed; system running in low power mode) using the connected USB
devices. Set to +5VSB to allow wake up from S3 sleep state (no power to CPU;
RAM in slow refresh; power supply in reduced power mode). The default set-
ting for the three jumpers is 1-2 to select +5V (because not all computers have
the appropriate power supply).

NOTES:
1. This feature requires an ATX power supply that can supply at least 2A on

the +5VSB lead when these jumpers are set to +5VSB. Otherwise, the
system does not power up.

2. The total current consumed must NOT exceed the power supply capability

(+5VSB) whether under normal working conditions or in sleep mode.