Asus P4T-F - Manual (Page 15)

15
3. HARDWARE SETUP
ASUS P4T-F User’s Manual
3.2 Layout Contents
Motherboard Settings
1) JEN p. 18 JumperFree ™ Mode (JEN) (Disable / Enable)
2) SW1 (Switches 6-10) p. 19 CPU Ext. Freq. Selection (SW1 Switches 1–5)
3) SW1 (Switches 1-4) p. 20 Manual CPU Ratio Settings (SW1 Switches 7-10)
4) USBPWR p. 21 USB Device Wake-up (USBPWR)
5) ADN p. 22 Onboard Audio Codec (Enable/Disable)
6) J3-J3-/OC3 p. 22 USB2 / CNRUSB Selection
Memory, CPU and Expansion
1) RIMMA1/A2/B1/B2 p.23 184-Pin System Memory Support
2) CPU p.25 Central Processing Unit (CPU)
3) Heatsink p.26 CPU Heatsink Retention Module Installation
4) PCI1/2/3/4/5 p.29 32-bit PCI Bus Expansion Slots
5) AGP Pro p.31 Accelerated Graphics Port (AGP Pro) Slot
6) CNR p.31 Communications and Networking Riser (CNR) Slot
Connectors
1) PS2KBMS p.32 PS/2 Mouse Connector (6 pin female)
2) PS2KBMS p.32 PS/2 Keyboard Connector (6 pin female)
3) PRINTER p.33 Parallel Port Connector (25 pin female)
4) COM1, COM2 p.33 Serial Port Connector (Two 9 pin male)
5) USB p.33 Universal Serial Bus Ports (Two 4 pin female)
6) GAME_AUDIO p.34 Joystick/MIDI Connector (15 pin female) (optional)
7) LINE-IN, -OUT, MIC p.34 Audio Port Connectors (Three 1/8” female)(optional)
8) FLOPPY p.34 Floppy Disk Drive Connector (34-1pin)
9) PRIMARY/SECONDARY IDE p.35 Primary/Secondary IDE Connectors (Two 40-1 pin)
10) MAIN_FAN, CPU_FAN p.36 Fan Connectors (Three 3 pin)
PCI_FAN
11) USB2 p.37 USB Header (10-1 pin)
12) MODEM, CD_IN, AUX p.37 Internal Audio Connectors (Three 4 pin) (optional)
13) MIC2 p.38 Internal Microphone Connector (3 pin) (optional)
14) HEADPHONE p.38 Headphone Connector (3 pin) (optional)
15) IR p.39 Standard Infrared (SIR) Module Connector (5 pin)
16) HDLED p.39 IDE Activity LED (2 pin)
17) ATXPWR, ATX12V, (AUXPWR) p.40 Power Supply Connector (20 pin, 4 pin) (6 pin)
18) PWRLED (PANEL) p.41 System Power LED Lead (3-1 pin)
19) KEYLOCK (PANEL) p.41 Keyboard Lock Switch Lead (2 pin)
20) SPEAKER (PANEL) p.41 System Warning Speaker Connector (4 pin)
21) MSG.LED (PANEL) p.41 System Message LED (2 pin)
22) SMI (PANEL) p.41 System Management Interrupt Switch Lead (2 pin)
23) PWRSW (PANEL) p.41 ATX Power / Soft-Off Switch Lead (2 pin)
24) RESET (PANEL) p.41 Reset Switch Lead (2 pin)
Layout Contents 3. H/W SETUP