Drill Doctor 400 - Manual (Page 22)

20
www.DrillDoctor.com
4. Remove worn wheel by twisting
slightly and lifting wheel off
shaft. Install new wheel and
reinstall wheel retainer and
screws. Don’t over-tighten
mounting screws. Remove the
wrench and replace the wheel
access cover before turning on
the machine.
User Replaceable Parts
Accessories
• 1/2"-3/4" Chuck
(Part # DA40170PF)
• 100 Grit Coarse Diamond
Sharpening Wheel
(Part # SA01328GA)
• Carrying Case
(Part # PP40400PF)
Hub Wrench
(Part # PP01336SF)
Wheel Access Cover
(Part # PP40150PF)
3/32" to 1/2" Chuck
(Part # SA01504PA)
180 grit Standard Diamond
Sharpening Wheel
(Part # SA01326GA)
The use of any
accessory other than
one recommended in
this user’s manual may
present a risk of
personal injury.
Grit Tube and Cap
(Part # DA40120PF)