Accessories – Drill Doctor 350X User Manual

Page 11

www.drilldoctor.com

Reversing or Replacing Your
Diamond Sharpening Wheel

Disconnect your Drill Doc-
tor

, make sure machine is

cool, then remove Wheel
Access Cover.

Use wrench supplied with
your Drill Doctor to lock
sharpening wheel in place.

With Phillips-head screwdriv-
er, remove the two screws
and wheel retainer.

Remove worn wheel by twist-
ing slightly and lifting wheel
off shaft. Install new wheel
and reinstall wheel retainer
and screws. Don’t over-tight-
en mounting screws. Remove
the wrench and replace the
Wheel Access Cover before
turning on the machine.

Accessories

Order Accessories through our website: www.Drill-
Doctor.com

, or by contacting us at the phone num-

ber listed on the Warranty page (page 20), or at the
retailer where you purchased your

Drill Doctor

Standard Diamond Sharpening Wheel

(180 grit)

DA31320GF

WARNING:

The use of any accessory other than one rec-
ommended in this user’s manual may present
a risk of personal injury.

Coarse Diamond Sharpening Wheel

(100 grit)

DA31325GF