Datamax-O'Neil VMP SERIES Horizontal Mount Vibration Bracket - Manual

Horizontal Mount Vibration Bracket
(220146-000)
The following parts are included with the horizontal
mount vibration bracket (Figure 1):
(1) Mounting plate
(2) Rubber feet
(2) Foot caps
(1) #8-32 x 3/8 Torx pan head screw [not shown]
(1) #8-32 x 3/8 Phillips pan head screw [not shown]
(1) Instruction sheet [not shown]
The following hardware (not included) is required for
mounting:
(4) #10 pan head screws [screw length to be
determined by the user]
(4) #10 washers
(4) #10 hex nuts
(1) #8 torx driver bit [optional]
Note: You may need additional hand tools and
mounting hardware depending on your
installation.
Figure 1
Mounting
Plate Foot
Cap Security
Catch
Locking
Screw Hole Mounting
Holes Rubber
Foot
Paper
Feed
Direction
Selecting a Location for the Bracket
Orientation Guidelines
Use the following graphics as a guide for orienting
and/or mounting your printer:
If the paper is fed from above the printer (Figure 2):
If the paper is fed from below the printer (Figure 3):
VMP 1000
X: 0° to 60 °
VMP 2000
X: 0° to 30°
VMP 1000
X: 30° to 60°
VMP 2000
None
Figure 2
Paper
In
Paper Exit
X
Figure 3
Paper
In
Paper
Exit
X
Selecting a Location for the Bracket
(continued)
General Guidelines
•
Position the bracket and/or printer with enough
room to properly open and close the printer.
• Position the bracket and/or printer so it is
protected from environmental elements such as
moisture, tools, and boxes.
• Position the bracket and/or printer in a secure
area in normal traffic patterns.
• Do not position the bracket above, near, or
relative to, the driver's position as to interfere
with normal driving operations.
• Mount the bracket and/or printer away from the
driver's head to eliminate potential injury in the
event of an accident.
• Cabling: All power to the printer must be fused.
Make sure the fuse box is connected properly.
• Hole centers:
Left to right = 10 3/8".
Up and down = 1 5/8".
Recommended hole diameter for #10 pan head
screw is 13/64" drill bit (.203").
Assembling the Bracket
1. Align the rubber feet under the mounting plate
so that the ends of the mounting plate fit into
the recesses of the rubber feet and the side
with the rubber bosses are closest to the
edge, facing up (Figure 4).
2. Attach the rubber feet to the mounting plate
(Figure 5).
3. Place the foot caps over the mounting plate
so that the recesses are facing up (Figure 6).
The foot caps attach to the bracket when the
bracket is mounted.
Figure 4 Figure 5
Figure 6