Datamax-O'Neil PrintPAD MC70_75, CN3, CN3e Vehicle Mount Bracket - Manual (Page 2)

Step 1a: (Continued)
3. Use the supplied Cable Tie (P/N 370030-001)
to attach the power supply cable to the
mounting bracket at the two lower-most holes
in the tray area. Some AC adapters have a
ferrite bead that may interfere with the cable
installation under the metal plate. If so, route
the ferrite bead to the side of the bracket, as
shown in the photo below.
4. Proceed to Step 2: Attaching the Printer.
Step 2: Attaching the Printer
1. Make sure the vehicle mount bracket is in the
unlocked position.
2. Place the printer in the vehicle mount bracket,
bottom first. Make sure it is flush against the
bracket.
3. Facing the printer, move the locking lever to
the “locked” position (from the left to the right)
until it “clicks” into the “locked” position.
Agency Approvals
Applicable Directive
•
89/336/EEC, 73/23/EEC
Applicable Standards
•
EN55022 (1998)
• EN55024 (1998)
• EN60950 (1992)
Warranty
The Company warrants that Datamax-O’Neil products are free
from defects in manufacturing materials and workmanship for one
(1) year from date of original purchase to Buyer/Distributor (OEMs
90 days from the date of purchase). Batteries, cables, power
supplies, and other accessories will be warranted for ninety (90)
days. Datamax-O’Neil makes no other warranties, expressed or
implied, including implied warranties of merchantability and fitness
of purpose.
If you try to repair, disassemble, or change the product in any way,
or use parts not provided by Datamax-O’Neil without prior, written
authorization, all warranties are void. For complete warranty and
service information, see the Warranty Card included in your
printer's original packaging.
No Liability for Negligent Use
In no event shall Datamax-O’Neil be held liable for any damages
whatsoever (including, without limitations, damages for loss of
profits, business interruption, loss of information, or other
pecuniary loss) arising out of negligence in use and care of the
product.
COPYRIGHT © 2010, DATAMAX-O'NEIL
Note: Make sure you regularly clean the
charging contact points on your printer's case to
ensure your printer's batteries are properly
charged and to avoid damage to the printer or
charger. To clean the charging contact points,
unplug the charger from the wall and clean
using alcohol and a clean rag.
Warning: Do not allow the charging points to
come in contact with metal objects.
(2) Charging contact points
Charger's socket (5.5 mm
DC jack, center pin positive)
Cable tie
Fuse Box/ Cigarette
AC Adapter
Lighter
Note: As an option, for security purposes,
attach a padlock to the padlock hole when the
locking lever is in the “locked” position. This will
prevent others from “unlocking” the locking
lever.
-5- -6-
MC70/75, CN3, CN3e PrintPAD
110226-005
LP3
Vehicle Mount Bracket