Determining battery condition, Installing the driver, Using a handheld computer (hhc) – Datamax-O'Neil PrintPAD CN3_4_3e_4e User Guide User Manual

Page 5

PrintPAD CN3/4 & PrintPAD CN3e/4e USER'S GUIDE

The Charge LED flashes red when charging and flashes green when fully charged. The Charge LED is visible when the

printer's lid is open or closed. A complete charge takes approximately 7-9 hours. For more information on the Charge

Determining Battery Condition

You can determine the relative battery condition by printing a self-test. For more information, see

. On the printout, “Battery Volt” varies between 6.8 and 8.4 volts.

Installing the Driver

1. Go to www.datamax-oneil.com and click

Support

to obtain the appropriate driver for the PrintPAD CN3, CN3e, CN4,

or CN4e.

2. Install the driver onto the handheld computer.

Using a Handheld Computer (HHC)

1. Insert the handheld into the cavity by sliding it in from the top.
2. Press down until the handheld is fully latched and seated (Figure 5).

Note: To obtain full battery capacity, a new battery must cycle through two to three charges. To restart a charge,

unplug the power cord. Wait 30 seconds, then replug the power cord.

The CN3/3e and CN4/4e Handheld Computer will charge while power is plugged into the DC power port.

Caution: Do not plug DC power into the internal and external power ports at the same time.

Do not plug the DC power supply into the printer if the printer is being charged by means of external charge

contacts.

Caution: There is a risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries

according to the instructions.

The operating temperature of this portable printer is 50° C. However, the operating temperature when used with

Datamax-O’Neil power supply for charging the portable printer is limited to 40° C. Charge the printer in a suitable

location that meets this temperature requirement.

(For US/Canada) Use only the Datamax-O’Neil part number 220240-100 power supply with this product.

Note: Before using a CN3/3e or CN4/4e and the printer, it is necessary that the appropriate USB driver is installed.

Refer to the USB Installation Guide for more information.

Figure 5