Datamax-O'Neil OC-2_3 SERIES Swivel Lock Bracket - Manual (Page 2)

OC 2/3
110218-002
Swivel Lock Bracket
Step 2: Attaching the Printer
1. Make sure the swivel mount bracket is in the
unlocked position.
2. Place the printer’s swivel mount block over the
unlocked swivel lock bracket.
3. Facing the printer, move the locking lever to the
“locked” position (from the left to the right) until it
“clicks” into the “locked” position.
Agency Approvals
Applicable Directive
•
89/336/EEC, 73/23/EEC
Applicable Standards
•
EN55022 (1998)
• EN55024 (1998)
• EN60950 (1992)
Warranty
The Company warrants that Datamax-O’Neil products are free from
defects in manufacturing materials and workmanship for one (1) year
from date of original purchase to Buyer/Distributor (OEMs 90 days
from the date of purchase). Batteries, cables, power supplies, and
other accessories will be warranted for ninety (90) days. Datamax-
O’Neil makes no other warranties, expressed or implied, including
implied warranties of merchantability and fitness of purpose.
If you try to repair, disassemble, or change the product in any way, or
use parts not provided by Datamax-O’Neil without prior, written
authorization, all warranties are void. For complete warranty and
service information, see the Warranty Card included in your printer's
original packaging.
No Liability for Negligent Use
In no event shall Datamax-O’Neil be held liable for any damages
whatsoever (including, without limitations, damages for loss of profits,
business interruption, loss of information, or other pecuniary loss)
arising out of negligence in use and care of the product.
COPYRIGHT © 2010, DATAMAX-O'NEIL
Note: If you would like to charge the printer while it is
attached to the swivel lock bracket, plug the power
connector (right angle cable only) into the printer, then
attach the printer to the bracket. Make sure the
charging cord is hanging straight down and does not
interfere with the swivel lock bracket.