Datamax-O'Neil microFlash 4te User Guide - Manual (Page 6)

MICROFLASH 4TE PRINTER USER'S GUIDE
3
Using Batteries: General Guidelines

If your printer came with batteries already installed,
remove the red, battery isolator labels. If your
printer did not come with batteries installed, see
Installing and/or Replacing Batteries on this page .

If you are storing your printer for a long period of
time, reinstall the battery isolator labels.

Both batteries must be installed for your printer to
operate properly.
Installing and/or Replacing Batteries
1. Open the printer's cover (Figure 5).
2. Lift the battery cover up by pushing the retainer clip
inward with your finger (Figure 6).
3. Lift up the outside end of the battery to remove it.
4. Insert or replace the new batteries. Verify the
battery contacts are facing down and are on the
outside edge of the printer (Figure 7).
5. Close the battery cover by snapping it into place.
Figure 5
Figure 6
Figure 7
Battery
contacts