Datamax-O'Neil LP3 Hand Strap Clip Replacement Kit - Manual (Page 2)

LP3
110222-002
LP3
Hand Strap Clip Replacement Kit
Replacing a Split Ring
1. Make sure the hand strap and male snap are
removed.
2. Remove the split ring by inserting an item, such as
a flathead screwdriver or a coin, into the split ring.
3. Slide the split ring through the fixed mounting loop
on the LP3 printer, and continue until the split ring
is removed.
4. Slide the new split ring onto the fixed mounting loop
until it is secure.
5. Reattach the male snap and the hand strap.
Agency Approvals
Applicable Directive
•
89/336/EEC, 73/23/EEC
Applicable Standards
•
EN55022 (1998)
• EN55024 (1998)
• EN60950 (1992)
Warranty
The Company warrants that Datamax-O’Neilproducts are free from
defects in manufacturing materials and workmanship for one (1) year
from date of original purchase to Buyer/Distributor (OEMs 90 days
from the date of purchase). Batteries, cables, power supplies, and
other accessories will be warranted for ninety (90) days. Datamax-
O’Neil makes no other warranties, expressed or implied, including
implied warranties of merchantability and fitness of purpose.
If you try to repair, disassemble, or change the product in any way, or
use parts not provided by Datamax-O’Neil without prior, written
authorization, all warranties are void. For complete warranty and
service information, see the Warranty Card included in your printer's
original packaging.
No Liability for Negligent Use
In no event shall Datamax-O’Neil be held liable for any damages
whatsoever (including, without limitations, damages for loss of profits,
business interruption, loss of information, or other pecuniary loss)
arising out of negligence in use and care of the product.
COPYRIGHT © 2010, DATAMAX-O'NEIL