BEI Sensors High Resolution Inclinometers - Manual (Page 15)

Page 15 Inclinometer RS232 – Current Datasheet Version: 20130503
INCLI NO MET E R
RS2 32 – CURRENT
Example for Setting the Output Rate
Instruction To the sensor Response sensor Description
„X=±xx.xxx“, CR, LF,
”Y=±xx.xxx“, CR, LF,
”X= . . . continuous sending of
angles
activate temporary
polling mode
”f” “f“ the continuous sending
of angle values are
stopped, instructions
can send to the sensor
switch to the setup
level
”prog” ”P“ Sensor is at setup level
set rate of data
transmission for
continuous mode
“O5“ “O5” Code transmission rate
is set to 1Strings/s
Reset “q“ “q“ Software-Reset will be
executed, the new
settings are guilty
„X=±xx.xxx“, CR, LF,
”Y=±xx.xxx“, CR, LF,
”X= . . . continuous sending of
angles at
1 Strings/s
We do not assume responsibility for technical inaccuracies or
omissions. Specifications are subject to change without notice.