CHIEF QMP1L - Manual (Page 6)

QMP1L Installation Instructions
6
2. Open the cable management bracket on the height-adjust
arm by sliding bracket towards the edge of the arm. (See
Figure 8)
NOTE: If necessary, cable management bracket attach screws
may be loosened using hex key (S).
Figure 8
CAUTION: Ensure that adequate cable slack exists for
movement of laptop, and that cables will not be pinched when
bracket is closed.
3. Carefully insert cables into bracket. (See Figure 9)
Figure 9
4. Close cable management bracket by sliding it back towards
the centerline of the arm. (See Figure 8)
NOTE: If necessary, cable management bracket attach screws
may be tightened using hex key (S).
5. Carefully insert cables in cavity located in lower portion of
non-height adjustable arm. (See Figure 10)
6. Install cable management cover (G) with two #8-32 x 3/8"
Phillips flat head screws (P). (See Figure 10)
Figure 10
ADJUSTMENTS
Swing Arm Pivot/Swing
1. Using 3/16" hex key (S), slightly loosen or tighten the
adjustment screw(s) as necessary. (See Figure 11)
Figure 11
OPEN Position CLOSED Position
Attach
Screws
View from Bottom
Cable Management
Bracket (in open position)
Cable Path (typical)
Cable Path
(typical)
(G) x 1
(P) x 2 6
(Cart/stand not shown)
1