CHIEF KTA320_325 - Manual (Page 4)

Models: KTA-220/225 and KTA-320/325 Installation Instructions
4
INSTALLATION
1. Assemble pole clamp back (90) to pole mount front
using two FW (110) and two BHCS (100) using a
5/32" hex key. (See Figure 2)
2. Secure pole mount back (90) to pole mount front and
pole by tightening two BHCS (100) using a 5/32" hex
key.
3. Secure pole mount back to pole mount front and pole
by tightening three BHCS using 5/32" hex key.
Figure 2: Mount Array on Pole
Display Installation
Attach Centris Head to Flush Mount Display
CAUTION: If display uses a screw size other than
those included in the kit, DO NOT use the screws
provided. Using the wrong screws could result in
damage to your monitor.
1. Install two M4 x 12mm Phillips pan head screws (30)
into two upper mounting holes in display back.
(See Figure 3)
NOTE: DO NOT fully tighten at this time.
2. Hang display on Centris head. (See Figure 4)
3. Install bottom two M4 x 12mm Phillips pan head
screws (30) through Centris head mounting holes and
into lower mounting holes in display back.
4. Tighten four M4 x 12mm Phillips pan head screws
(30).(See Figure 5)
Figure 3: Prepare Display
Figure 4: Hang Display
Figure 5: Secure Display to Centris Bracket
Pole Clamp Back (90)
Pole
(110)
(100)
Pole Mount front
with Array
Display
M4 x 12mm Phillips Pan Head Screw (30)
Display
Centris Head
Array Rail
Display
M4 x 12mm Phillips Pan Head Screw (30)
Centris Head
Array Rail