CHIEF KSA1011 - Manual (Page 4)

Model: KSA-1011 Installation Instructions
4
ASSEMBLY
ASSEMBLE Y-CONNECTOR TO MOUNT
Y-Connector (10) may be installed to either a desk or wall
mount (mount not included). See applicable assembly
instructions that follow.
Desk Mount
1. If previously attached, disconnect cables from
display, then remove display. See instructions
included with desk mount and/or interface.
2. If previously attached, loosen (do not remove) clamp
attach screw (See Figure 2). Remove desk mount
from desk. See instructions included with desk
mount.
Figure 2: Disassemble Desk Mount
3. Turn mount assembly upside down and place in your
lap. With one hand, grasp desk mount housing and
lift slightly off lap. With other hand, using 3/16" hex
key, loosen and remove mount arm attach screw and
other related items (See Figure 2). Retain all items,
except stop plate, for later mount arm assembly.
NOTE: Slightly lifting desk mount housing will keep nut in
recessed cavity, assisting screw removal.
NOTE: After mount arm is removed, nut can be retrieved
by turning desk mount housing upside down.
4. Remove stop screw and stop collar from mount arm
(See Figure 2). These will not be reused with Y-
connector (10).
5. Using 2.5mm hex key, remove and retain desk mount
base plate and attach screws (See Figure 3).
Figure 3: Desk Mount Base Plate
6. Turn desk mount housing right side up and install pin
(20) into housing (See Figure 4).
Figure 4: Assemble Y-Connector to Desk Mount
Desk Mount Housing
Clamp Attach Screw
Stop Plate
Spacer
Pin
Mount Arm
Washer (Stainless Steel)
Washer (Plastic)
Washer (Stainless Steel)
Mount Arm Attach Screw
Stop
Collar Stop
Screw
Nut
Base Plate
Attach Screws
(3 places)
Desk Mount
Housing
Clamp
Desk Mount Housing
50
70
60
70
10
40 or 30
20