CHIEF K1D Series - Manual (Page 14)

K1D Series Installation Instructions
14
Display Removal - Standard Faceplate
WARNING: Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 22)
1. Make sure display is in the upright position.
2. Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 22)
Figure 22
Display Removal - Custom Faceplate
WARNING: Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 23)
1. Press quick release tab on back of display to release
display from faceplate. (See Figure 23)
2. Pull bottom of display away from faceplate. (See Figure 24)
3. Lift display up from faceplate. (See Figure 23) and (See
Figure 24)
Figure 23
Figure 24
Pivot Adjustment Range
Single Arm Models
1. Adjust arm angle as desired up to 90 degrees in either
direction. (See Figure 25)
WARNING: Swinging the arm beyond 90 degrees may
result in the mount slipping off the desk causing serious
injury!
Figure 25
quick release tab
2
quick release tab
3
1
3
2
(top view)
+/- 90 degrees range
of motion
pivot point of the arm