CHIEF CM2C40 - Manual (Page 20)

CM2C40 Installation Instructions
20
Figure 30
CM2C40 Interface Board Hardware Information
(See figure 30)
Dry Contact Closures
The unit provides dry contact outputs for system feedback, or to control other devices.
To complete circuits to external devices:
1. Connect the common wire from your switch to terminal 7. (See figure 31)
2. Connect the 'up' wire from your switch to terminal 5.
3. Connect the 'down' wire from your switch to terminal 6.
Figure 31
1st Position of connector array
1st Position of connector array
1st Position of switch array