Allied Telesis AR700 - Manual (Page 18)

Features in 281-01 18
Version 281-01
C613-10482-00 REV A
Level 4
CR Module Level Description
AR400 AR7x5 AR750S
/
AR77
0S
Rapi
er
i
A
T-
8800
A
T-
8600
A
T-
8700
XL
A
T-
8948
/
x90
0-
4
8
A
T-
9900
A
T-
9800
CR00010159 GUI 4 When the web-based GUI is used to add or remove ports from a port-based
VLAN association on an AT-9812T switch, the icons representing alternate ports
faced opposite directions.
This issue has been resolved. The port icons now all have the same orientation.
- - - - - - - - - Y
CR00011311 IPsec 4 In output of the commands show ipsec policy and show ipsec policy
sabundle, the value for the number of bytes currently used by each SA bundle
was sometimes truncated.
This issue has been resolved, and both commands now display the correct
number. As part of this, output of the command show ipsec policy has been
modified so that the expiry limits in bytes and in seconds display on separate
lines.
Also, if the expirykbytes parameter of the command create or set ipsec
bundlespecification was given a value higher than 4193280, the router or
switch instead used a lower value.
This issue has been resolved. If you specify a value above 4193280, the router or
switch now displays a warning message and sets the expiry limit to 4193280
kbytes.
Y Y Y Y Y - - - - -
CR00011788 IP Gateway 4 Previously the switch allowed users to specify the tag parameter when creating
or modifying a blackhole route with the commands add or set ip route.
However, blackhole routes cannot be tagged, so the switch did not apply the tag
setting in its saved configuration.
This issue has been resolved. If a command contains both the blackhole and tag
parameters, the switch now returns an error message.
- - - - - - - Y Y -