Allied Telesis AR700 - Manual (Page 11)

Features in 281-01 11
Version 281-01
C613-10482-00 REV A
CR00012900 IPv6, Switch 2 When an IPv6 accelerator card was installed, IPv6 multicast traffic was flooded to
all ports in a downstream VLAN, whether or not they had joined the multicast
group.
This issue has been resolved.
- - - - - - - Y Y -
CR00012911 Switch, VLAN,
User
2 Under very rare circumstances, memory corruption could occur when packets
were transmitted by the CPU out a switch port.
This issue has been resolved.
Y - Y - - - - - - -
CR00012951 IPv6 2 RIPng (for IPv6) sometimes sent sub-optimal routes to its neighbours. When
RIPng was configured in a network with loop topology, this could cause unstable
routing table entries on the neighbours (the metric kept being updated, as a
result of updates from neighbours).
This issue has been resolved. RIPng no longer sends sub-optimal routes.
Y Y Y Y Y - - Y Y Y
CR00012952 Bridge 2 If a tagged packet was bridged out of a VLAN interface, the interface always
added a VLAN tag into the packet, even though the packet was already tagged.
This issue has been resolved.
Y Y Y - - - - - - -
CR00012991 ATM 2 The maximum allowed value of the vpi parameter in the commands add and set
atm channel has been increased from 8 to 15. Y - - - - - - - - -
CR00013003 EPSR, Switch 2 When EPSR is enabled, it creates a classifier so it can send EPSR packets to the
CPU for processing. Previously, if too many classifiers existed and therefore EPSR
could not create the classifier, EPSR was enabled anyway. However, it did not
work correctly.
This issue has been resolved. Now, if EPSR cannot create the classifier, an error
message displays and EPSR is not enabled.
- - - - - - - Y Y -
CR Module Level Description AR4
0
0
AR7
x
5
AR7
50S / AR770S
Ra
pi
er
i
AT
-8
8
0
0
AT
-8
6
0
0
A
T-
8
7
00XL
A
T-
8
9
48 / x900-
48
AT
-9
9
0
0
AT
-9
8
0
0