CEMB USA K9 - Manual (Page 7)

7
Use and maintenance manual Rev. 04-2011
ENGLISH
Starting
3. Starting
WARNING
B
EFORE SWITCHING ON THE MACHINE
,
MAKE SURE THAT ALL THE
CONNECTIONS DESCRIBED IN THE
INSTALLATION
CHAPTER
HAVE BEEN MADE CORRECTLY .
T
HE FOLLOWING OPERATIONS INVOLVE A POTENTIAL RISK FOR
THE OPERATOR , GIVEN THE PRESENCE OF VOLTAGE ON THE
EQUIPMENT
. T
HE
P
ERSONAL
P
ROTECTIVE
E
QUIPMENT DESCRIBED
IN THE
INSTALLATION
MANUAL MUST BE WORN AND WORK
MUST BE DONE WITH DUE CARE AND ATTENTION .
O
PERATIONS MAY ONLY BE PERFORMED BY A
SPECIALISED TECHNICIAN .
Before powering the machine, carry out the following
checks:
check that the balancing machine touches the floor 1.
at the three support points;
2. make sure that all the parts of the balancer are cor
rectly connected and fixed;
3. make sure that the parameters (voltage and frequency)
of the mains power supply are compatible with those
indicated on the rating plate of the balancer;
4. make sure the power cable is correctly connected;
5. make sure the machine shaft and flange hole are
clean.
CAUTION
A NY TRACES OF DIRT MAY AFFECT BALANCING ACCURACY .
6. To switch on the balancer press the switch on the
left-hand side of the machine.
7. Position the wheel on the terminal with the inner part
facing the balancer;
8. Firmly attach the wheel to the balancer shaft using
the lock nut.
9. The pedal controls a mechanical brake which facili
tates locking the locking ring and positioning the
wheel for correction.
10. At this point, you can read the tyre measurements
and perform balancing.