CEMB USA K10 User Manual - Manual (Page 10)

10
K10 EVO - Use and maintenance manual Rev. 04-2009
ENGLISH
4.2 MENU
This is used to personalise some balancer functions and
to perform calibrations.
To access this section, press the FUNCTIONS MENU
button.
The first function, OPT, concerns unbalance optimisa-
tion. It is described in the previous paragraph. To enter
this section, press ENTER. To move on to the next
point, press .
INFORMATION
The order of the information shown on the display
can vary depending on whether the arrow up or arrow
down button is pressed. The sequence of the illustra-
tions shown below refers to use of the arrow up button.
DIAMETER
If you do not need to edit this section, move on to the
next one by pressing .
If you wish to edit it:
Press or to set the diameter in mm or
inches, then press ENTER to confirm the selected unit
of measurement.
Press to move on to the next phase.
WIDTH
If you do not need to edit this section, move on to the
next one by pressing .
Control panel
If you wish to edit it:
Press or to set the width in mm or inches,
then press ENTER to confi rm.
Press to move on to the next phase.
APPROXIMATION
If you do not need to edit this section, move on to the
next one by pressing
If you wish to edit it:
Press or to set approximation to 5 or 1 g or
to 0.25 or 0.1 oz, then press ENTER to confirm.
Press to move on to the next phase.
SETUP
The SETUP function is used to access machine diagnos-
tics and calibration. Both operations are described in the
following paragraphs.
Press to return to the previous menu.