Hunter 99179, 99180, 99181 Original Accessory Control and Canopy Kit - Manual (Page 7)

M0093-01 • 02/03/14
1.888.830.1326
7
Push the two canopy halves from the kit
together around the hanging system.
Make sure that the receiver is tucked
inside. Partially install the canopy screws
from the kit into the screw holes. Slide
the canopy up close to the ceiling.
Tighten all four screws.
Tighten the setcrew.
Setscrew
Canopy
Screw
Canopy
Screw
Installing or changing the battery
To access the battery compartment
remove the small Phillips head screw
that secures the battery door to the
transmitter assembly. Replace with a
CR2032 battery when necessary. The
battery should be installed with the
positive (+) side up.
Phillips
Head
Screw
Battery
Door