Hunter 25271 Globe Fitter User Manual
Read and save these instructions
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LLATION INSTRUCTIONS FOR HUNTER CEILING FAN
LIGHT MODELS 26610 - 26619 SERIES
READ AND SAVE THESE INSTRUCTIONS
CAUTION:
1. TO REDUCE THE RISK OF FIRE AND ELECTRICAL SHOCK, INSTALL THIS LIGHT KIT ONLY ON LISTED
HUNTER CEILING FANS TYPE A THRU Z.
2. READ ENTIRE INSTRUCTIONS CAREFULLY BEFORE BEGINNING INSTALLATION
3. TO AVOID POSSIBLE ELECTRICAL SHOCK, BE CERTAIN ELECTRICITY IS TURNED OFF AT FUSE OR CIRCUIT
BREAKER PANEL BEFORE WIRING.
4. ALL WIRING MUST BE IN ACCORDANCE WITH NATIONAL AND LOCAL ELECTRICAL CODES. IF YOU ARE
UNFAMILIAR WITH WIRING, YOU SHOULD USE A QUALIFIED ELECTRICIAN.
PRELIMINARY STEPS
(SEE FIG. 1)
INSERT PIPE NIPPLE (TDP DF LAMP SPCKET) THRDUGH CENTER HDLE IN FITTER.
PLACE LDCKWASHER AND NUT DN PIPE NIPPLE. (FINGER TIGHTEN BNLY)
REMDVE ENDBELL FRDM PULLCHAIN AND FEED THRDUGH BELMPUTH NUT. ALIGN SOCKET WITH
BELMDUTH NUT. TIGHTEN NUT DN PIPE NIPPLE.
REATTACH ENDBELL TD PULLCHAIN.
CONNECT WIRES TO FAN
(SEE FIG. 2)
NOTE:
* SEE FAN INSTALLATION INSTRUCTIONS FOR CONNECTING HOUSE WIRING TO THE FAN.
* CONNECT HOUSE WIRING TO THE FAN BEFORE ATTACHING THE FAN LIGHT TO THE FAN.
* SEE WIRING DIAGRAMS ON REVERSE SIDE FOR FAN LIGHT USE WITH WALL SWITCHES.
DISCONNECT POWER TD CEILING FAN AT THE MAIN PANEL.
REMDVE AND DISCARD SWITCH HOUSING COVER PLATE (IF INCLUDED) FRDM FAN. RETAIN THE SCREWS.
MAKE ELECTRICAL CONNECTIONS. SEE DIAGRAMS DN REVERSE SIDE.
INSTALL SWITCH HOUSING COVER SCREWS BACK ONTO SWITCH HOUSING. LEAVE SPACE UNDER THE
SCREW HEADS FOR THE FAN LIGHT. ASSEMBLE FAN LIGHT TO SWITCH HOUSING AND TURN COUNTER
CLOCKWISE SO THAT THE SCREWS SLIP INTO THE KEYHOLE SLOTS. TIGHTEN SCREWS.
ASSEMBLE LAMP BULB TD FAN LIGHT, USE 3-WAY LAMP BULB NO LARGER THAN 50/100/150 WATTS,
ASSEMBLE THUMB SCREWS (PROVIDED) TD GLOBE FITTER. ASSEMBLE SILENCER BAND (PROVIDED)
TD GLASS GLOBE (SOLD SEPARATELY). TIGHTEN SCREWS.
7. RECONNECT POWER TD COMPLETE INSTALLATION.
8. CAUTION IF GLOBE BEGINS TO BUZZ, CHECK TO MAKE CERTAIN THE GLOBE SCREWS ARE TIGHT.
9. ANYTIME THE GLOBE IS REMOVED AND REASSEMBLED, THE GLOBE FITTER SCREWS MUST BE CHECKED
FDR TIGHTNESS.
FORM NO.
SIDE 1
41367-01
2/98