Hunter 28129 Four-Light White Straight Arm Fitter - Manual (Page 8)

8
43558-01 • 05/18/09 • Hunter Fan Company
Switch
Housing
Plate
Screw
Wires and
Wire Connectors
Screw and
Washer
Pendant
Cover
Step 1
Step 3 Step 4
1. Uninstall the two screws from the switch housing.
2. Remove the wire connectors from the two wires in the switch housing
labeled “Connect Light Here” or “For Light Use.” One wire is white and the
other wire is black/white striped.
Connect the black/white striped wire from the switch housing to the black
wire from the light kit. Connect the white wire from the switch housing
to the white wire from the light kit. Secure all wire connections using wire
connectors.
To connect the wires, hold the bare metal leads together and place a wire
connector over them, then twist the wire connector clockwise until tight.
CAUTION: Be sure no bare metal wires or wire strands are visible after
making the connections.
3. Finish attaching the light kit to the switch housing. Use the two screws
removed from the switch housing and the lock washers on the red tag.
Partially install the screws into the light kit and the housing. Rotate the
light fixture clockwise until the screws are locked into the narrow ends of
the keyhole slots. Securely tighten the two screws.
WARNING: Improper installation could cause the light fixture to fall, or
result in electrical shock or personal injury.
4. Reattach the decorative pendant cover to the light kit using the screws you
removed earlier.
5. Go to the instructions for Installing the Bulbs, Chains, and Shades.
Installing the Light Kit on the Hunter Original