Hunter 28129 Four-Light White Straight Arm Fitter - Manual (Page 4)

4
43558-01 • 05/18/09 • Hunter Fan Company
1. Unscrew the three screws from the upper switch housing. Disconnect
the 9-pin plug connectors. Remove the lower switch housing.
2. Push the plug button from inside the lower switch housing to remove
the plug button and switch housing cap. Unscrew the two attachment
screws on the bottom of the switch housing.
NOTE: Save the plug button and switch housing cap should you
choose to remove the light fixture in the future.
3. Feed the two wires from the light kit up through the center hole in the
lower switch housing. Align the keyholes of the light kit and the screw
holes of the lower switch housing.
4. Install the nut and washer onto the threaded rod from the light kit.
Removable Switch Housing
9-Pin Plug
Connector
Lower Switch
Housing
Plug Button
Screw
Steps 1-2
WARNING: Improper installation could cause the light fixture to fall.
Washer
Threaded
Rod
Nut
Step 4
Installing the Light Kit on Fans With Removable Switch Housings