Hunter 99093, 99094 4-Light Fitter With Glass - Manual (Page 6)

MA008-01 • 08/15/13
1.888.830.1326
6
TYPE-B ASSEMBLY INSTRUCTIONS
Using the single pin connectors, connect
the black or blue wire from the fan to the
black wire from the light kit. Connect the
white wire from the fan to the white wire
from the light kit.
If your fan does not have pin connectors on
the wires coming from the switch housing,
install the wiring harness provided. Using
the provided wire connectors connect the
white wire from the fan to the white wire
from the wire harness and connect the
black or blue wire from the fan to the black
wire from the wire harness.
Feed the wires through the center hole in
the switch housing, the washer, and the nut.
Push the center hole in the gasket over the
threaded rod of the light kit. Then install the
switch housing by twisting clockwise onto
the threaded rod. Install the washer and nut
onto threaded rod and tighten securely.
Lift the light kit assembly up so that the
screw holes in the lower switch housing
line up with the holes in the upper switch
housing. Install the switch housing
screws and tighten securely.
Wire
Connector
Switch
Housing
Do not allow the light kit to hang
only by the wire connections!
1 2
Switch
Housing
Screw
4 3
Washer
and Nut
Switch
Housing
Wire
Harness